The IP&S Company is an authorized partner of GTE Gmbh in Poland and a distributor of the Advanced Discovery System  ADICOS®.
It is specially designed for fire detection on coal, biomass and waste material transportation, storage, processing installations.

For more than 10 years the ADICOS® systems have been used in the scope of fire protection systems in power & utility plants, cement industry, wood processing industry in Poland.

The ADICOS® system enables detection of the following hazards:

• detection of smouldering (flameless fire) of coal, biomass, waste materials and alternative fuels before the occurrence of an open fire by means of:
  • multi-criteria, multi-sensor fire gas detectors type GSME equipped with semiconductor sensors of fire gases, such as carbon monoxide (CO), nitrogen oxides (NO_x), hydrogen (H₂), hydrocarbons (HC). GSME detectors are resistant to high dust concentration at a sensitivity level sufficient for early detection of smouldering of flammable materials and flame fires.
    
    ... read more
    
    

• ADICOS FIRELASER – linear laser spectroscope detectors with a detection path up to 100 m long, using CO₂ laser beam in IR band. The measurement of fire gases absorption is carried out based on spectroscopic analysis of the beam and is therefore immune to dust, dirt and humidity in the air.
• other special gas and temperature detectors
  
  
• detection of hot spots like an ember, smouldering or overheated material transported on conveyors and stored in silo, bunkers, heaps as well as monitoring of the temperature of machinery, engines, gearboxes and other devices in order to detect overheating by means of:
  
  • smart IR array thermometer detectors type HOTSPOT 1000. Measurement by 32x31 thermopile array sensor. These sensors perform thermal imaging of the object and allow to set the alarm-triggering temperature threshold for each cell.
    
    ... read more
    
    

The detectors store configuration data sent from the ADICOS® Central Software installed on a service computer. It allows support for up to 256 detectors.
The system has distributed memory - the detector decides about the alarm based on a comparison of configuration data with current values and remembers the measured values for one week.
The ADICOS system offers intelligent signal evaluation and wide operation and control capabilities. 

The BMZ-30 control panel is a compact central unit that communicates with all GSME, HOTSPOT and FIRELASER units via the ADICOS® M-Bus and displays and evaluates their states. It allows to group detectors and to create alarm rules.
It provides communication signals for up to 127 ADICOS® detectors and builds the interface link between the ADICOS® installation and the service-PC. This connection is based on RS-232 serial interface by default - ethernet and conventional modem extension modules are available.

M-BUS Master XF is another type of master unit for the ADICOS® System, which also provides similar communication signals but for more detectors - up to 256 ADICOS® detectors. The other difference is that M-BUS Master does not have an interface. 
It has the ingress protection rating IP65 so it can be mounted on installation.

The system can be remotely-controlled and supervised through ADICOS® Central Software not only on-site by means of a service PC computer but also via a phone or GSM modem or Ethernet network card.

 Applications:

• coal and biomass transport systems, conveyors and installations in buildings at power and co-generation stations, cellulose processing/paper production and wood processing plants, waste and food processing installations and other production facilities,
• storehouses, bunkers and silos for the storage of coal, biomass, alternative fuels and waste material dumps,
• storage and production facilities where fire detection by means of conventional detectors is impossible or largely impaired due to the presence of dust, humidity or steam.

In this area we offer:

• Burner Automation & Control Systems
• The COSS: Combustion Optimization Support System – Advanced Flame Monitoring System for burner optimization, balancing and diagnostics
• Ignition Systems for Burners
• Complete low NOx Oil and Gas Burner Installations

The offer covers consulting, design, delivery, services, including:

• Burner Management Systems, control systems and certified safety systems, with programming, start-up and optimization
• fuel and air supplying installation, atomizing media trains, with measuring, control, safety installations, cabinets, cables, pipes, valves & fittings, other materials
• manufactured and assembled by IP&S electrical High Tension and High Energy Igniters, Gas Igniters &Pilots
• commissioning, start-up and optimization, service & maintenance
• approvals of notified body e.g. Polish Technical Inspection CLDT (UDT)

We offer Igniters & Pilots manufactured & assembled by IP&S:

• High Tension Igniters
• High Energy Igniters
• Natural and Forced Draught Gas Igniters & Pilots 
  
  ... read more

We offer equipment manufactured by world leading companies of which we are authorized distributors:

FIREYE Inc.

• Burner controls and flame safeguard systems -  equipped with UV and IR range detectors without self-checking, ionization rod or UV and IR scanners with self-checking. 
  
  ... read more
  
  
  
• Flame monitoring systems for multi-burner applications -  for continuous operation burners:

of a separated design: UV and IR scanners and amplifiers

... read more

integrated Flame Scanners: a range from the simplest devices to complex ones, microprocessor-based ones - the most advanced being the Insight II scanner of exceptional discrimination capabilities. Thanks to the incorporated communication features via the RS serial bus, these scanners additionally allow to assess the combustion process quality and burner optimization & balancing.
They are intended for application in plants operating in both safe zones and explosion hazard zones, as well as for installations of Safety Integrity Level up to SIL-3.

... read more

• The FIREYE flame monitoring systems are the most widely used multi-burner control systems in Poland and around the world.

FORNEY Corp.

• High Energy Spark Igniters type HESI 90  -  electric ignition devices for direct ignition of gas and oil igniters and burners, manufactured and assembled by IP&S in the standard version as well as in Ex version for explosion hazard zones
  
  ... read more
  
  
  
• Gas igniters type FORNEY MAXFire®  -  for use in intermittent applications and for continuous duty as pilot burners
  
  ... read more
  
  
  
• Other Combustion Products - details and offer on request:

-   Burner Management Systems and Flame Detectors
-   Oil Igniters type DURAFire® and other Gas and Oil Igniters
-   Oil and Gas Burners types PAF, PAFII, NOxMiser, rigid and flexible oil guns
-   Duct Burners for Combined Cycle Plants, perimeter and SCR Burners
-   Dampers: shut-off, bypass, stack of all sizes

Thousands of devices, mainly High Energy Spark Igniters and Gas Igniters, have found application on furnaces and boilers in Poland, in power & heating plants, refineries, petrochem and other industries.

We offer complete Fire and Gas Safety Solutions for High Hazard Industrial Installations, including:

• POG - installations in Petrochemical, Oil and Gas industry
• chemical plants 
• power and utility plants
• special production plants
• aircraft hangars
• hazardous materials storage sites

We have completed many projects in Poland of different scope: from concept development, documentation, delivery of equipment, to the delivery of the complete Fire and Gas Detection System for installations like above

Our offer includes fire and gas detection devices and systems of highest world class manufacturers: 

• Norwegian company Autronica Fire and Security A.S. of which we are an authorized Polish distributor in the field of solutions for the Petrochemical, Oil and Gas industry and other High Hazard installations  (POG & HH installations) 
• American company Detector Electronics Corporation, of which we are the authorized Polish distributor 
  

We can offer EN54 certified Autronica AutroSafe 4 Fire Detection System including fire panels with components like control & repeater panels, wide range of detectors, MCP's. We offer a complete presentation system AutroMaster Integratred Safety and Emergency Management System  for control and monitoring of protected areas.
We can also offer POG version of the AutroSafe 4 system with IEC 61508 SIL2  approved fire and gas panel as well as fire and gas detectors, for safe and hazardous areas.

For fire and gas detection in hazardous areas we offer Det-tronics Eagle Quantum Premier Loop Hazard Monitoring System in IEC 61508 SIL2  approved version with fire and gas detectors SIL2  and ATEX certified. EQP can work with the AutroMaster Integratred Safety and Emergency Management System.

More about offered products you can find below:

X-Series Flame Detectors:

• Resistance to adverse environmental conditions
• High sensitivity and long detection range
• Exceptional immunity to false alarm sources
• ATEX, SIL2 - certified

        ... read more

Infra Red Point Hydrocarbons Gas Detectors:

• Periodical calibration not required
• High immunity to poisoning
• Up to 5-year guarantee period
• ATEX, SIL2 - certified

        ... read more

Catalytic Combustible Gas Detectors:

• Can be used for detection of hydrogen and virtually all other combustible and flammable gases 
• ATEX, SIL2 - certtified (see description)

        ... read more

Infra Red Open Path Hydrocarbons Gas Detectors:

• Easy installation and operation
• High tolerance to collinearity errors
• ATEX, SIL2 - certified

        ... read more

Electrochemical Toxic Gas Detectors: 

• Improved accuracy, high stability and reliability
• ATEX, SIL2 - certified

        ... read more

Acoustic Gas Leak Detection System:

• Advanced analysis of ultrasonic sound characteristics
• Immediate response
• Operation not affected by wind, fog or rain
• ATEX, SIL2 - certified

        ... read more

 
Gas Transmitters, Universal Displays, Controllers:

• Process the sensor signal to the outputs to the master systems
• Enable local reading, setting and one-person non-intrusive calibration
• ATEX, SIL2 - certified

        ... read more

Hazard Event Monitoring System:

• Gas detection-only or integrated Fire & Gas System
• ATEX, SIL2 - certified

        ... read more

The IP&S Sp. z o.o. company is the authorized distributor in Poland of SSP Fire Detection Systems, devices for gas and fire detection and hazard signalling by the Norwegian company Autronica.

We provide interactive fire and gas detection systems for any application on land and in the petrochemical, oil, and gas industry, depending on the application and the corresponding technical capabilities of the devices:

• Standard FDS - „Land”:

These are the basic solutions of Fire Detection systems intended for facilities listed in the Regulation of the Ministry of Interior and Administration of Poland of June the 7, 2010, including for commercial and office buildings, museums, theatres, cinemas, entertainment and sports halls, hospitals, high and high-rise public buildings and others, not requiring any special working conditions as below.

Our company offers solutions selected for complete fire and gas safety, optimized for various facilities, e.g. hospitals, cultural heritage buildings, railway stations, airports, industry and others in order to maximally protect life, environment and property.

Autronica develops, manufactures and services all of its solutions and places high demands on quality throughout the production, supply and service chain. Autronica products are certified according to European directives (CPD) requiring EN 54 approval.

Basic devices meet additional requirements of the Ministry of Interior and Administration, which is confirmed by relevant certificates issued by CNBOP.

• Special solutions for the petrochemical, oil and gas industries - "POG & HH" Petrochem, Oil, Gas and High Hazard solutions:

They are intended for installations requiring Safety Systems (SIS) with a certain Safety Integrity Level (SIL), in safe or potentially explosive areas.

The product range includes AutroSafe® IFG (Integrated Fire and Gas Detection System) with SelfVerify, the world's first Integrated Addressable Fire and Gas Detection System conforming to IEC 61508 at Safety Integrity Level (SIL 2). We also offer a full line of flame and gas detectors, high sensitivity smoke detection (HSSD), aspiration systems, alarm management and control systems.

For years, Autronica has been the preferred supplier of fire and gas safety systems to the petrochemical, oil and gas markets worldwide. It creates world-class products, constantly develops new products while ensuring the safety of an entire industry where thousands of lives depend on them every day and night.

Our fire and gas detection systems are developed in accordance with global standards and regulations and comply with the EN 54 standard.

IP&S Sp. z o.o. (Ltd.) is an engineering company that specializes in industrial automation & safety systems for industrial, power & utility and commercial facilities.

We undertake a wide range of activities related to industrial burner installations as well as fire detection and fire-fighting systems for both safe and explosion hazard zones in the industry.

We specialize in Petrochem, Oil, Gas & High Hazard Installations (POG & HH).

IP&S offers:

• engineering including technical consultancy, support and design
• delivery of equipment and complete systems
• installation, commissioning & optimization
• service and maintenance

IP&S provides a wide range of services ranging from delivery to complete turn-key installation as the system integrator.

We offer products of the highest quality and reliability including SIL certified products. Our offer also includes execution of installations with the required Safety Integrity Level. 


Our offer is dedicated to High Hazard installations in:

• refineries and petrochemical works (POG installations)
• oil and gas mining industry including transmission and storage facilities (POG installations)
• power & utility, heating plants
• chemical plants
• pulp and paper
• special production facilities
  
• storage facilities for hazardous materials and/or high-value objects, e.g. aircraft hangars, ammunition storages etc.

Our company is the sole authorized Polish distributor of products of the manufacturers:


FIREYE Inc. -  from Derry NH, USA, the world leader in the range of industrial burner flame safeguard systems

FORNEY Corp. -  from Carrollton TX, USA, the manufacturer of high quality igniters, power and industrial burners

DETECTOR ELECTRONICS Corp. -  from Minneapolis MN, USA, the world leader in the range of flame and combustible or toxic gases detection systems as well as unique hazard events monitoring systems for hazardous areas on POG & HH installations

AUTRONICA Fire and Security A.S. -  from Trondheim, Norway, the manufaturer of complete fire and gas safety solutions, in the range of petrochemical, oil and gas industry and other hazardous installations (POG &HH)

GTE Gmbh -  from Viersen, Germany. It offers the unique ADICOS Early Warning Detection System based on GSME detectors of smoldering gases and HOTSPOT IR sensor-array temperature detector which allow flameless fire detection and overheating, hot-spot detection before the open fire starts. It is assigned for early detection of biomass and coal fires on transport, storage and process installations

We have implemented the Quality Management System in compliance with PN EN ISO 9001: 2015 standard which is confirmed by the relevant Certificate.

We are registered in GIG (Central Mining Institute) as the manufacturer of equipment for hazardous areas. GIG carries out annual audits of our manufacturing system.